Le test Cisco 350-021 est l'un très improtant dans tous les tests de Certification Cisco, mais c'est toujours difficile à obtenir ce Certificat. La présence de Pass4Test est pour soulager les candidats. L'équipe de Pass4Test peut vous aider à économiser le temps et l'éffort. Vous pouvez passer le test sans aucune doute sous l'aide de notre Q&A.
Si vous voulez ne se soucier plus à passer le test Cisco 350-021, donc vous devez prendre la Q&A de Pass4Test comme le guide d'étude pendant la préparation de test Cisco 350-021. C'est une bonne affaire parce que un petit invertissement peut vous rendre beaucoup. Utiliser la Q&A Cisco 350-021 offerte par Pass4Test peut vous assurer à réussir le test 100%. Pass4Test a toujours une bonne réputation dans l'Industrie IT.
Le test Cisco 350-021 peut bien examnier les connaissances et techniques professionnelles. Pass4Test est votre raccourci amené au succès de test Cisco 350-021. Chez Pass4Test, vous n'avez pas besoin de dépenser trop de temps et d'argent juste pour préparer le test Cisco 350-021. Travaillez avec l'outil formation de Pass4Test visé au test, il ne vous demande que 20 heures à préparer.
Code d'Examen: 350-021
Nom d'Examen: Cisco (CCIE SP Cable Qualification Exam)
Questions et réponses: 399 Q&As
Si vous voulez se prouver une compétition et s'enraciner le statut dans l'industrie IT à travers de test Certification Cisco 350-021, c'est obligatoire que vous devez avior les connaissances professionnelles. Mais il demande pas mal de travaux à passer le test Certification Cisco 350-021. Peut-être d'obtenir le Certificat Cisco 350-021 peut promouvoir le tremplin vers l'Industrie IT, mais vous n'avez pas besoin de travailler autant dur à préparer le test. Vous avez un autre choix à faire toutes les choses plus facile : prendre le produit de Pass4Test comme vos matériaux avec qui vous vous pratiquez avant le test réel. La Q&A de Pass4Test est recherchée particulièrement pour le test IT.
350-021 Démo gratuit à télécharger: http://www.pass4test.fr/350-021.html
NO.1 Upon deleting an IOS image file from flash, an execution of show flash shows the file still in flash, with
a 'D' preceding it (as shown in the exhibit). What step must be taken in order to remove the file
completely?
A. Erase the file from flash
B. Format the flash device
C. Replace the flash card - it is defective
D. Execute a squeeze command on the flash device
Answer: D
Cisco 350-021 certification 350-021
NO.2 The name of the DOCSIS config file to download will be offered to the cable modem in what DHCP
field?
A. giaddr
B. config-filename
C. packet-filename
D. siaddr
Answer: C
Cisco 350-021 350-021 350-021 350-021
NO.3 Unity gain is being used for alignment. The first amplifier from the node has 25 dB of gain and is 2000
feet away with cable loss of 1 dB per 100 feet. The node has an output of 35 dBmV at 55.25 MHz. What is
the input at the amplifier?
A. 13dBmV
B. 3dBmV
C. 15dBmV
D. 27dBmV
Answer: C
Cisco examen 350-021 examen 350-021 350-021 examen 350-021 examen 350-021
NO.4 HFC cable television return path networks are aligned to provide: (multiple answer)
A. Asymmetrical gain since the downstream and upstream bandwidths are also asymmetrical
B. Unity gain with a fixed input level and varying output levels adjusted by the selection of a fixed value
attenuator and equalizer at the output stage in each of the return amplifiers in the network
C. Unity gain with a fixed output level and varying input levels adjusted by the selection of a fixed value
attenuator and equalizer at the input stage of each of the return amplifiers in the network
D. Cable modems the ability to power range comfortably within their output power dynamic range
E. It is not necessary to align the return path amplifiers since the CMTS will automatically adjust the cable
modem transmit power levels.
Answer: BD
certification Cisco 350-021 examen 350-021
NO.5 If there are two different headends with two different frequencies available sharing the same plant, what
frequency will the two groups of cable modems, which are brand new, and have never been on-line, lock
on?
A. They will lock on the frequency configured on the linecard.
B. They will lock on the frequency configured on the upconverter.
C. They will lock on the first frequency they find.
D. They will lock on the lowest frequency.
E. They will lock on the last frequency remembered in ram.
Answer: C
Cisco examen 350-021 certification 350-021 350-021 350-021 350-021 examen
NO.6 What is NOT an ATM class of service?
A. CBR
B. VBR-t
C. ABR
D. UBR
E. CAR
Answer: E
Cisco 350-021 350-021 certification 350-021 350-021
NO.7 Which are HFC cable television forward path networks aligned to provide? (multiple answer)
A. For asymmetrical gain since the downstream and upstream bandwidths are also asymmetrical
B. For unity gain with a fixed input level and varying output levels adjusted by the selection of a fixed
value attenuator and equalizer at the output stage in each of the forward amplifiers in the network
C. For unity gain with a fixed output level and varying input levels adjusted by the selection of a fixed
value attenuator & equalizer at the input stage of each of the forward amplifiers in the network
D. It is not necessary to align the forward path amplifiers since the CMTS will automatically compensate
for forward path gain discrepancies.
E. For unity gain and are level compensated by automatic gain and slope control systems utilizing RF pilot
reference carriers
Answer: CE
Cisco examen 350-021 certification 350-021 350-021 examen certification 350-021 350-021
NO.8 What is the purpose of rate decoupling for ATM transmission?
A. It provides transparency between SONET and SDH.
B. It converts higher-speed DS3/E3 to lower-speed optical rates.
C. It processess the packing and unpacking of frames into 53-octet cells.
D. It allows lower-speed traffic on an ATM facility without causing traffic gaps.
Answer: D
certification Cisco 350-021 examen 350-021 350-021 350-021
NO.9 For an OC-48 signal (2.5Gb/s), what is the BER (bit error rate) if there is 1 bit error every four days?
A. 10E-12
B. 10E-13
C. 10E-14
D. 10E-15
E. 10E-16
Answer: D
Cisco 350-021 350-021 350-021 350-021
NO.10 What describes a technique, used to encapsulate voice (NOT data) over ATM?
A. RFC 1483
B. LANE
C. AAL-1
D. RFC 1577
Answer: C
Cisco certification 350-021 350-021 certification 350-021
NO.11 In a cable HFC plant, which devices are modulators? (multiple answer)
A. CMTS line card
B. Upconverter
C. Diplex filter
D. Set top box
E. Fiber node
Answer: AD
Cisco examen certification 350-021 350-021 examen
NO.12 A DOCSIS 2-way data system is being designedto limit upstream traffic. Unknown modems should be
kept from using precious Upstream bandwidth. Given these requirements, it should beensured that the
DOCSIS configuration file has what set?
A. Vendor-specific information field
B. Max-cpe should be set to 1
C. CMTS authentication field should be set
D. Network Access should be set to 0
E. Downstream frequency should be set above 450 MHz
Answer: D
Cisco examen 350-021 examen 350-021 350-021 350-021 350-021 examen
NO.13 What effect will this configuration command have?
line vty 0 4
no password vtypassword
A. All telnet connections to the router will be denied.
B. Only one telnet connection at the router will be allowed at a time.
C. Virtual terminal sessions will not be able to enter enable mode.
D. Virtual terminal sessions will not be asked a user-level password.
E. It will have no effect.
Answer: A
Cisco examen certification 350-021 350-021 examen 350-021 examen
NO.14 Every time a typing mistake is made at the exec prompt of a router, the message from the router
indicates a lookup is being performed. Also, there is a waiting period of several seconds before the next
command can be typed. Can this behavior be changed?
A. No, this is a built in feature of Cisco IOS? software.
B. Yes, use the no ip domain-lookup command.
C. Yes, use the no ip helper-address command.
D. Yes, use the no ip multicast helper-map command.
E. Yes, use the no exec lookup command.
Answer: B
Cisco examen 350-021 350-021 examen
NO.15 A router is set to boot from flash, but cannot find boot commands in the configuration. Also, valid files
do not exist in the default flash device. The router will:
A. Boot from ROM, since there are no valid sources
B. Try to boot from the network, using a default filename
C. Terminate the boot process with an error message
D. Try to boot from the network, then boot from ROM as a backup
Answer: D
Cisco examen 350-021 examen 350-021
NO.16 A network administrator is using debug commands to check the performance of a network. What steps
can the administrator take to ensure that the "debug" will not require too much CPU, or at least that she
will not have to reboot the router to disable debug? (multiple answer)
A. Make the debug command as specific as possible
B. Use the max-time parameter of the debug command
C. In configuration mode, enter scheduler interval 15
D. Configure a loopback to channel debug traffic
Answer: AC
Cisco certification 350-021 350-021 examen
NO.17 Cisco recommends the use of a headend-grade coaxial cable or a quad-shield coaxial cable with a
minimum of 60% + 40% braid and double foil insulation to connect the cable modem cards to the HFC
network. The center conductor must be straight and extend 1/8 inch (3.2 mm) beyond the end of the
connector, and the connector should be securely crimped to the cable. Select three recommended cable
types that can be used to connect the Cisco uBR7200 series universal broadband routers: (multiple
answer)
A. RG 58
B. RG 59
C. RG 59/U
D. RG 6
E. RG 7
Answer: BCD
Cisco 350-021 certification 350-021 350-021
NO.18 There are two different headends with two different frequencies available sharing the same plant.
There is a -10dB cable loss to the second active in the cascade. What is the required pad for balancing
A. A 0 pad
B. A 1 pad
C. A 2 pad
D. A 3 pad
E. A 4 pad
F. A 5 pad
Answer: F
Cisco certification 350-021 350-021 examen 350-021 350-021
NO.19 For communications systems what describes the over-all health of the system?
A. Bit-Error-Rate (BER)
B. Synchronous Optical NETwork (SONET)
C. Optical Signal to Noise Ratio (OSNR)
D. None of the above
Answer: A
Cisco 350-021 350-021
NO.20 Given a PAL HFC and 8 MHz channel lineup in the downstream, is it possible to utilize 6 MHz DOCSIS
cable modems and signals on the network?
A. No, only 8 MHz channel spacing is available for Downstream data signals
B. Yes, as long as the 6 MHz DOCSIS signal is within a valid 8 MHz channel
C. Yes, as long as the DOCSIS signal is upconverted through a PAL upconverter
D. No, DOCSIS cannot be mixed with EuroDOCSIS in the Donwstream
E. DOCSIS must be used only in an EIA-542 channel plans
Answer: B
certification Cisco certification 350-021 certification 350-021 350-021
Aujourd'hui, il y a pleine de professionnels IT dans cette société. Ces professionnels sont bien populaires mais ils ont à être en face d'une grande compétition. Donc beaucoup de professionnels IT se prouver par les tests de Certification très difficile à réussir. Pass4Test est voilà pour offrir un raccourci au succès de test Certification.
没有评论:
发表评论